If the intermediate slice preview ever hangs up you've found the culprit - take a close look at the slices on each side of the current location. Go to the slices panel and hold down SHIFT while clicking and dragging your mouse left to right. The quickest way to find the source of the problem is to use our intermediate slice scrubbing feature. as boardcad, aku and shape3d are not targets of hackers nor would exploits of these files and apps. The major goal here is just to make sure there's no sharp corners the cutter can't get to. On another note, file sharing of these relatively simple board files should be by nature almost 100 safe. In general you just want to make sure any points that should be continuous have the "Cont" checkbox checked, and that your tangents are kept relatively close to their blue point. We typically see these guys in the following places: Sharp outside corners (eg square rails) are fine - it's sharp inside corners (eg channels) that create problems. Cut within 8 inches of the tail of the blank (the '. Just drag the blue point away from the curve and the twist will become obvious. Key Points: -Center your design within the blank, but outside the carbon fiber 'Brain'.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |